Save the battery information

This article describes the configuration of a battery on the Climkit platform.

For connection planning, or for further information, please refer to the links at the end of the article.

Procedure for registering a battery on the Climkit platform

Entering the parameters of the site's battery or batteries is necessary to monitor their performance. This information allows for comparing storage potential with the energy actually stored.

  1. Under Site > Parameters > Equipment: check Battery
  2. Under Equipment > Other equipment > Battery Click the (+) button to add a battery and fill in the following fields:
    1. Name (location): Title of the battery or its location.
    2. Capacity (kWh): Battery capacity in kWh.
    3. Charge power (kW) : Nominal recharge capacity of the battery in kW. If the power is limited compared to the maximum power, enter the limited power.
    4. Connection type (coupling):
      1. AC: the battery is equipped with its own AC -> DC converter for charging and its own DC -> AC inverter for discharging.
      2. DC: the battery is connected directly to the hybrid photovoltaic inverter which also manages the battery's charging and discharging.
    5. Battery meter: select the meter to which the battery is connected. For AC connected batteries only.
  3. Repeat operation 2 above for each battery connected behind a dedicated battery meter.

Climkit electrical meter connection diagram
Fact Sheet - Energy Storage – Photovoltaic Batteries

How Did We Do?

Registering photovoltaic installation info

Adding charging stations

Contact